Hold it; you need to be careful: sometimes as you.

May 15, Todays how to video is on removing and replacing your upper control arm and ball joint on your chevy truck.

its a pretty simple do it yourself job, that just. Jul 05, Remove the 18mm nut securing the upper control arm ball joint to the knuckle. With the nut removed, pull the control arm free from the knuckle. At this point there is no tension on the camber bolts of the two attachment brackets. Figure 9. Jack up the wheel knuckle to loosen tension from the upper control arm.

Step 7 – Remove the old upper control arm. 6. Remove upper control arm flange bolts and spin arm degrees to gain access to the control arm bushings. Removal Instructions:(Using Optional “C-Clamp” Adapter Kit) 7.

Install receiver tube over large end of bushing and install extractor plug on small end of bushing. (See Fig. 1 & 2) 8. Oct 22, The experts at 1A Auto show you how to replace the front control arms on your Chevy Silverado or GMC Sierra. step 1:Disconnecting the Strut. Pull the wire off the 18mm nut on top of the strut. Remove the three 18mm nuts that hold the top of the strut.

Created on:

step 2:Removing the Wheel. Jul oak tree removal tuolumne county, Chevrolet Silverado How to Replace Upper Control Arm.

One result of serious truck driving is the wearing out of one or more upper control arms, resulting in the added failure of the connection bushings, the ball joints, or all of the above. Aug 08, Use a 18mm wrench or socket loosen and remove the nut on either side of the arm.

4. Remove the Upper Control Arm. After both nuts have been removed slide the bolts from the control arm mounts while keeping the adjusters in order. To remove the control arm use a upward motion on the arm while pulling outward. 5. Aug 08, 5. Replace the Bushings. If you are replacing just the bushings then continue with this guide. If you are replacing the entire control arm then continue onto number 6 in this guide.

In the image below you can see the old bushing is torn allowing the control arm to wonder around in its mounts which causes brake pull and irregular tire wear.

It may cost you around 54 toto get an aftermarket control arm replacement for your Chevrolet K The price depends on a few factors, including brand, series, and quantity, though other factors may also come into play.

Chevrolet K control arm replacements are typically sold individually or in sets of two units. Using an open end wrench, hold the shock absorber upper stem to prevent it from turning, then remove the upper stem retaining nut, the retainer and rubber grommet. Common front shock absorber mounting-2WD vehicles.

Take those bolts out, press down on the suspension some, and bring the strut down, and then up and out.

Remove the shock absorber-to-lower control arm retaining bolts and lower the shock absorber assembly from the bottom of the control. Chevy Astro GMC K K Tahoe Yukon 4WD Front Driver Upper Control Arm (Fits: Chevrolet K)Was:Free shipping.

14 Pcs Suspension Kit for Chevrolet K 4WD Tie Rod End (Fits: More than one vehicle)Moog K Front Lower Control Arm Bushing Kit Set of 4 for GM Pickup Truck SUV.