Weight2, weight3, and weight4 are set to 0, and these queues are in shared.
Aug 22, Report Inappropriate Content. PM. PM. Hi Ahmed, The above command should remove only VLAN from the configuration (see below): LAB (config)#do sh run i span spanning-tree mode pvst spanning-tree extend system-id spanning-tree vlan, priority LAB (config)#Z LAB#sh Aug 23 %SYSCONFIG_I: Configured from console by console LAB#sh span root Root Hello Max Fwd Vlan Root ID Cost Time Age Dly Root Estimated Reading Time: 1 min.
The nonroot switches receive and process one BPDU during each configured time period.
End with Remove vlan from spanning tree. bushcutting.bar01(config)#spanning-tree vlan 1 bushcutting.bar01(config)#exit bushcutting.bar01# To disable Spanning Tree Protocol (STP) on an IOS based switch use"no spanning-tree vlan vlan_number" command from global configuration mode as shown below. Mar 02, Although it is not recommended, you can turn off Spanning Tree Protocol (STP) on a per-VLAN basis, or globally on the switch. Use the no spanning-tree vlan vlan-id command in order to disable Estimated Reading Time: 2 mins.
Removes range of VLAN IDs. remove forward-time. Removes the spanning tree forward interval. remove hello-time. Removed the spanning tree hello interval. remove max-age. Removes the spanning tree maximum tree removal service wilmington de interval. remove priority. Removes the spanning tree priority interval.
Sep 22, To reduce the number of active spanning-tree instances, you have a several options: If your switches are all Cisco and running in VTP server or client mode, then you can enable VLAN pruning on the VTP server (s) with the vtp pruning command.
This will prune unnecessary VLANs from your trunk links automatically.